Valentine’s Day Wreath

Making your own wreath for the holidays is easy.  With this wreath tutorial, I’ll show you just how easy it is.

What you’ll need:

Grapevine Wreath

1 1/2″ wide wire edge ribbon & 2 1/2″ wide wire edge ribbon.  (one spool each that are 9′ long)

Purchased bow or make your own

Valentine’s day sprays (I used 3) Purchased at http://www.michaels.com/

hot glue gun & glue sticks

Chop stick or wooden dowel (to hold items in place while the glue dries, it saves fingers from getting burned)

paddle wire to anchor the bow to the wreath

wire cutters

Scissors

floral tape

Take apart the sprays using wire cutters.  Gather the parts in odd numbers, small bunches of 3 or 5.  Cut the longer pieces in half.  (they are much too long for the wreath).  Use the floral tape to create little bouquets.  I made little bunches of loops with several of the spray pieces, and several were left straight.  Leave the white sections in singles.  I also cut the stems of the sprays into small sections & used them as stems for some of the small sprays that I made to give them strength & to save my fingers from being burned.

I used 2 different sized ribbons to wrap the wreath & make the bow.  I laid the smaller ribbon on top of the wider ribbon.  Wrap the wreath with both ribbons, gluing in place as you go. I like letting some of the grapevine “curly Qs” peek out of the ribbon.

Add a bow to the side of the wreath. I usually put the bow on the side of the door that opens, (not the hinge side)  It’s my personal preference. but that’s up to you.  It’s your wreath.

Now you can start gluing in the little bouquets that you’ve made.  Start with the longer pieces, putting some above the bow & some below it. Then use some of the smaller bouquets in between the loops of the bow.  Add the white parts to the bow, scattering them evenly.

And you’re done!

I tied some fishing line to the back of the wreath and hung it from a small nail that is at the top of my door since it was going in the center of glass.  By the way, did you notice that there are no flowers on this wreath?  The white sections of the sprays add just enough so that you don’t need flowers.

1 thought on “Valentine’s Day Wreath

  1. This is so easy but elegant. Easy to make something that would be pricey if purchased in a boutique or specialty store. And it is a one of a kind . Thanks, Sam !

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.